Dish Drying in Sink Expandable Stainless Steel Dish Drainers for Kitchen Counter Dish Dryer V1369-AZ3-W-11243

Used for three scenarios: this dish rack is a great space saver that fits over most sinks. (note: please check if the size of your sink and the dish rack match before purchasing.) small volume and ideal for small kitchen: the dish rack is suitable for small families, it measures only 15.5 in x 10.4 in x 4.7 in, while it's capable of holding 8 plates and other bowls and glasses.

Multi-use dish drying rack: dish drainers expands for use on the countertop, in-sink or over-sink Fully expandable design - not just like other in sink dish drying rack only support bars can be adjusted, ours sink dish rack can be adjusted the main body rack to increase storage capacity and fits various sink. Sink rack dimensions: (13.9in-17in) l x 12inw x 4inh(not including adjustable support bars length). Please ensure the sink width is between 15 in to 20 inches, the lenght is more than 13 inches for a better fit. Rustproof And Long lasting: to prevent rust on the dish racks, this dish drainers for kitchen sink is made of food-grade stainless steel and constructed of thickened tube pipes, stable and high load bearing. You can clean it easily by rinsing it under a running tap, don't worry about the dish dryer getting rusty. Practical and sturdy: with 9 slots in total, the dish rack is sturdy enough and can quickly dry dishes, it can hold pot lids, plates, pot lids, cups, bowls, glasses, and comes with a removable utensil holder with drainage holes. The dish strainers for kitchen sink has anti-slip beads on both handles to prevent it from sliding when hanging over the sink, the bottom 4 feet is equipped with anti-slip rubber sleeves to protect your counter and sink from scratches Easy to install And Adjust: the sink drying rack comes with all tools needed (hex key, screws, nuts). Just follow the instructions to install it quickly. Plus, you can easily adjust it to 3 different sizes by loosening the screws, moving them to different holes on both sides, and tightening again with the hex key.